Wed. Nov 30th, 2022


In a new experiment of making a 12-volt free-energy generator, I present a simple model that uses magnets and a flywheel to generate electricity. The idea behind this prototype is to attract future researchers to research free energy and renewable energy. I’ll explain the workings of each component in this article. You can also see my video demonstrations below.


You’ve probably seen commercials for these free energy generators and wondered how they work. The answer is simple: they use 12 Volt Alternator. These units produce electricity in the form of DC current and are made from copper and have a low RPM. They’re an excellent choice for a DIY project and can run your entire home lighting system on 12V with battery backup.


This New Experiment of Making a 12 Volt Free Energy Generator is designed to produce electric power by using the power stored in a 12-Volt battery. The system uses twisted wires as winding wires. A hole is drilled in the spool’s flange, near the core. The start of the wire is then threaded through the hole and bent at 90 degrees. The wire is then applied around the spool’s shaft and begins to wind the coil.

The generator is a simple device that transforms mechanical energy to electrical energy. The mechanical energy can be obtained from a variety of sources. The simple device can be used to light a small torch bulb. The generator works using the same basic principles as power station generators. The device is easy to construct and can be used as a power source for a flashlight or other device.


A free-energy generator is possible to make with a simple capacitor and a 12-volt DC power supply. In this project, the capacitor is used as a voltage regulator. It regulates the voltage induced by the rotor. A bad capacitor will result in a low voltage reading from the generator. To check the capacitor’s condition, you will need a multi-meter with a capacitance reading. To discharge the capacitor, you will need a screwdriver with an insulated handle and cross the terminals of the capacitor. A loud pop will occur.

The capacity of a capacitor is directly related to its conduction abilities. A good capacitor can store a large amount of energy. However, they do not store as much energy as batteries. Although a battery is a cheaper option, it does not have the same capacity or energy density. A supercapacitor is better because it has a much higher energy density. It is also safer than a battery.


This flywheel for making 12-volt free-energy generator is made with the help of a motor and a capacitor. The transistor switches on when the flywheel starts rotating, and the capacitor reduces the load on the battery. When the motor starts, a reed switch is toggled during a portion of the flywheel’s rotation. The rest of the rotational time is used for free extra energy generation for the battery. The flywheel’s energy is transferred to the motor, which in turn charges the battery.

A flywheel is also useful for uninterruptible power supply (UPS), and as a way to improve the quality of electricity. Electrochemical batteries do not perform well as a UPS because they suffer from short life and insufficient cycle capacity. Furthermore, their operational life is shorter than batteries and they must be maintained carefully to keep the batteries operating. Using a flywheel is a great way to get started with free energy generation.

This power source can be a valuable addition to an existing grid or microgrid. With its ability to run for minutes or even hours, flywheels can improve the power quality in computer server centers. They can also be integrated into a microgrid serving the US Marine Corps in California. The advantages of a flywheel over a traditional energy source are many. The efficiency and reliability of a flywheel allow it to operate for several hours.

A flywheel for making 12-volt free-energy generator has many inherent advantages. For example, it can be easily started and dismantled, and it can last for hundreds of thousands of discharge cycles. Additionally, a flywheel produces no emissions and has no special disposal requirements. A flywheel for making 12-volt free-energy generator generates a high-quality stream of electricity with minimal maintenance. The flywheel has a significant footprint and is perfect for power generation during the industrial revolution.

By admin

Leave a Reply

Your email address will not be published. Required fields are marked *